ST-8927

How to install the Front Suspension Strut Bumper

FrontFits 8 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 8 cars it fits

Years	Make	Model	Engine	Choose
1999–2004	Chrysler	300M	V6 3.5L	Year
1998–2004	Chrysler	Concorde	V6 2.7L	Year
2002–2004	Chrysler	Concorde	V6 3.5L	Year
1998–2004	Dodge	Intrepid	V6 2.7L	Year
2000–2004	Dodge	Intrepid	V6 3.5L	Year
1998–2001	Chrysler	Concorde	V6 3.2L	Year
1999–2001	Chrysler	LHS	V6 3.5L	Year
1998–2001	Dodge	Intrepid	V6 3.2L	Year

Where it goes

1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
3
Front Suspension Strut Bumper
Front. Remove the old mount and bolt the new one in hand-tight.
4
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.