Rear Left Suspension Strut Mount

ST-8921

How to install the Rear Left Suspension Strut Mount

Rear LeftFits 3 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 3 cars it fits
YearsMakeModelEngineChoose
2009–2013ToyotaHighlanderL4 2.7L
2008–2013ToyotaHighlanderV6 3.5L
2008–2010ToyotaHighlanderV6 3.3L

Where it goes

FRONT OF CARDRIVER SIDEPASSENGER SIDE1
  • 1Rear Left Suspension Strut Mount: Rear Left

Install steps

  1. 1

    Get the car ready

    Loosen the wheel nuts, lift the car, support it on jack stands and take the wheel off.

  2. 2

    Take out the strut

    Unbolt the strut from the knuckle and the top mount, then lift it out. Compress the spring with a spring compressor before you undo the top nut.

  3. 3

    Rear Left Suspension Strut Mount

    Rear Left. Fit the new strut mount on the strut, then release the spring compressor slowly.

  4. 4

    Refit and test

    Put the strut back, tighten every bolt to your car's spec and refit the wheel. Get the wheel alignment checked.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.