Rear Suspension Shock Absorber Mount

ST-7985

How to install the Rear Suspension Shock Absorber Mount

RearFits 17 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 17 cars it fits
YearsMakeModelEngineChoose
2013–2015BMWX1L4 2.0L
2013–2015BMWX1L6 3.0L
2008–2013BMW128iL6 3.0L
2008–2013BMW135iL6 3.0L
2013BMW135isL6 3.0L
2012–2013BMW328iL4 2.0L
2007–2013BMW328iL6 3.0L
2013BMW328i xDriveL4 2.0L

Where it goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE1
  • 1Rear Suspension Shock Absorber Mount: Rear

Install steps

  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Rear Suspension Shock Absorber Mount

    Rear. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.