Front Suspension Strut Mount

ST-5910

How to install the Front Suspension Strut Mount

FrontFits 31 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 31 cars it fits
YearsMakeModelEngineChoose
2007–2014CadillacEscaladeV8 6.2L
2007–2014CadillacEscalade ESVV8 6.2L
2007–2014GMCSierraV8 5.3L
2008–2014GMCSierraV8 6.2L
2007–2014GMCSierra 1500V6 4.3L
2007–2014GMCSierra 1500V8 5.3L
2007–2014GMCSierra 1500V8 6.2L
2007–2014GMCYukonV8 5.3L

Where it goes

FRONT OF CARDRIVER SIDEPASSENGER SIDE11
  • 1Front Suspension Strut Mount: Front

Install steps

  1. 1

    Get the car ready

    Loosen the wheel nuts, lift the car, support it on jack stands and take the wheel off.

  2. 2

    Take out the strut

    Unbolt the strut from the knuckle and the top mount, then lift it out. Compress the spring with a spring compressor before you undo the top nut.

  3. 3

    Front Suspension Strut Mount

    Front. Fit the new strut mount on the strut, then release the spring compressor slowly.

  4. 4

    Refit and test

    Put the strut back, tighten every bolt to your car's spec and refit the wheel. Get the wheel alignment checked.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.