ST-2943
How to install the Rear Left Suspension Strut Mount
Rear LeftFits 1983–1985 Mazda 626
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
The car it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 1983–1985 | Mazda | 626 | L4 2.0L |
Where it goes
- 1Rear Left Suspension Strut Mount: Rear Left
Install steps
- 1
Get the car ready
Loosen the wheel nuts, lift the car, support it on jack stands and take the wheel off.
- 2
Take out the strut
Unbolt the strut from the knuckle and the top mount, then lift it out. Compress the spring with a spring compressor before you undo the top nut.
- 3
Rear Left Suspension Strut Mount
Rear Left. Fit the new strut mount on the strut, then release the spring compressor slowly.
- 4
Refit and test
Put the strut back, tighten every bolt to your car's spec and refit the wheel. Get the wheel alignment checked.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.