Front Suspension Strut Mount

ST-1926

How to install the Front Suspension Strut Mount

FrontFits 8 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 8 cars it fits
YearsMakeModelEngineChoose
1986–1995FordTaurusV6 3.0L
1993–1995FordTaurusV6 3.2L
1988–1995FordTaurusV6 3.8L
1986–1995MercurySableV6 3.0L
1988–1995MercurySableV6 3.8L
1988–1994LincolnContinentalV6 3.8L
1986–1991FordTaurusL4 2.5L
1986MercurySableL4 2.5L

Where it goes

FRONT OF CARDRIVER SIDEPASSENGER SIDE11
  • 1Front Suspension Strut Mount: Front

Install steps

  1. 1

    Get the car ready

    Loosen the wheel nuts, lift the car, support it on jack stands and take the wheel off.

  2. 2

    Take out the strut

    Unbolt the strut from the knuckle and the top mount, then lift it out. Compress the spring with a spring compressor before you undo the top nut.

  3. 3

    Front Suspension Strut Mount

    Front. Fit the new strut mount on the strut, then release the spring compressor slowly.

  4. 4

    Refit and test

    Put the strut back, tighten every bolt to your car's spec and refit the wheel. Get the wheel alignment checked.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.