Front Suspension Strut Mount

ST-1907

How to install the Front Suspension Strut Mount

FrontFits 36 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 36 cars it fits
YearsMakeModelEngineChoose
1984–1986ChryslerDaytonaL4 2.2L
1984–1986ChryslerLaserL4 2.2L
1986ChryslerLaserL4 2.5L
1984–1986ChryslerLeBaronL4 2.2L
1986ChryslerLeBaronL4 2.5L
1984–1986ChryslerNew YorkerL4 2.2L
1986ChryslerNew YorkerL4 2.5L
1984–1986Dodge600L4 2.2L

Where it goes

FRONT OF CARDRIVER SIDEPASSENGER SIDE11
  • 1Front Suspension Strut Mount: Front

Install steps

  1. 1

    Get the car ready

    Loosen the wheel nuts, lift the car, support it on jack stands and take the wheel off.

  2. 2

    Take out the strut

    Unbolt the strut from the knuckle and the top mount, then lift it out. Compress the spring with a spring compressor before you undo the top nut.

  3. 3

    Front Suspension Strut Mount

    Front. Fit the new strut mount on the strut, then release the spring compressor slowly.

  4. 4

    Refit and test

    Put the strut back, tighten every bolt to your car's spec and refit the wheel. Get the wheel alignment checked.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.