Suspension Solenoid

SO-7592

How to install the Suspension Solenoid

Rear or FrontFits 7 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 7 cars it fits
YearsMakeModelEngineChoose
2000–2004FordF-150V6 4.2L
2000–2004FordF-150V8 4.6L
2000–2004FordF-150V8 5.4L
1995–2003FordWindstarV6 3.8L
2002–2003LincolnBlackwoodV8 5.4L
1995–2000FordWindstarV6 3.0L
1993–1998LincolnMark VIIIV8 4.6L

Where it goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE11
  • 1Suspension Solenoid: Rear or Front

Install steps

  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Suspension Solenoid

    Rear or Front. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.