Suspension Solenoid

SO-7590

How to install the Suspension Solenoid

Rear or FrontFits 12 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 12 cars it fits
YearsMakeModelEngineChoose
1992–2011FordCrown VictoriaV8 4.6L
1991–2011LincolnTown CarV8 4.6L
1992–2011MercuryGrand MarquisV8 4.6L
2003–2004MercuryMarauderV8 4.6L
1995–1996LincolnContinentalV8 4.6L
1988–1994LincolnContinentalV6 3.8L
1984–1992LincolnMark VIIV8 5.0L
1990–1991MercuryGrand MarquisV8 5.0L

Where it goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE11
  • 1Suspension Solenoid: Rear or Front

Install steps

  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Suspension Solenoid

    Rear or Front. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.