3 Piece Front Engine & Auto Trans Mount Kit

ETK-940

How to install the 3 Piece Front Engine & Auto Trans Mount Kit

3 piecesFits 8 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 8 cars it fits
YearsMakeModelEngineChoose
2006–2011ChevroletHHRL4 2.2L
2006–2011ChevroletHHRL4 2.4L
2005–2010ChevroletCobaltL4 2.2L
2006–2008ChevroletCobaltL4 2.4L
2007–2008PontiacG5L4 2.2L
2007–2008PontiacG5L4 2.4L
2005–2007SaturnIonL4 2.2L
2006–2007SaturnIonL4 2.4L

What's in the box 3 pieces

  • Automatic Transmission Mount
    1

    Automatic Transmission Mount

    Front or Front Left

  • Rear Automatic Transmission Mount
    2

    Rear Automatic Transmission Mount

    Rear

  • Engine Mount
    3

    Engine Mount

    Front Right or Front

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE11233
  • 1Automatic Transmission Mount: Front or Front Left
  • 2Rear Automatic Transmission Mount: Rear
  • 3Engine Mount: Front Right or Front

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Automatic Transmission Mount

    Front or Front Left. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Rear Automatic Transmission Mount

    Rear. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Engine Mount

    Front Right or Front. Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.