3 Piece Front & Rear Engine Mount Kit

ETK-919

How to install the 3 Piece Front & Rear Engine Mount Kit

3 piecesFits 2004–2007 Ford Taurus

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

The car it fits
YearsMakeModelEngineChoose
2004–2007FordTaurusV6 3.0L

What's in the box 3 pieces

  • Front Right Engine Mount
    1

    Front Right Engine Mount

    Front Right

  • Rear Right Engine Mount
    2

    Rear Right Engine Mount

    Rear Right

  • Rear Engine Torque Strut Mount
    3

    Rear Engine Torque Strut Mount

    Rear

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE123
  • 1Front Right Engine Mount: Front Right
  • 2Rear Right Engine Mount: Rear Right
  • 3Rear Engine Torque Strut Mount: Rear

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Front Right Engine Mount

    Front Right. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Rear Right Engine Mount

    Rear Right. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Rear Engine Torque Strut Mount

    Rear. Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.