4 Piece Front Engine & Auto Trans Mount Kit

ETK-809

How to install the 4 Piece Front Engine & Auto Trans Mount Kit

4 piecesFits 2 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 2 cars it fits
YearsMakeModelEngineChoose
1997–2005BuickCenturyV6 3.1L
1997–2004BuickRegalV6 3.8L

What's in the box 4 pieces

  • Engine Mount
    1

    Engine Mount

    Front Right or Front

  • Automatic Transmission Mount
    2

    Automatic Transmission Mount

  • Engine Torque Strut Mount
    3

    2 × Engine Torque Strut Mount

    Front or Front Left

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE1133
  • 1Engine Mount: Front Right or Front
  • 2Automatic Transmission Mount
  • 3Engine Torque Strut Mount: Front or Front Left

Install steps

Good to knowReplace all 4 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Engine Mount

    Front Right or Front. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Automatic Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Engine Torque Strut Mount

    Front or Front Left. Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.