4 Piece Front & Rear Engine & Auto Trans Mount Kit

ETK-782

How to install the 4 Piece Front & Rear Engine & Auto Trans Mount Kit

4 piecesFits 2 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 2 cars it fits
YearsMakeModelEngineChoose
1999–2002MercuryVillagerV6 3.3L
1999–2002NissanQuestV6 3.3L

What's in the box 4 pieces

  • Automatic Transmission Mount
    1

    Automatic Transmission Mount

  • Engine Mount
    2

    Engine Mount

    Rear Right or Rear

  • Rear Left Engine Mount
    3

    Rear Left Engine Mount

    Rear Left

  • Front Engine Mount
    4

    Front Engine Mount

    Front

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE2234
  • 1Automatic Transmission Mount
  • 2Engine Mount: Rear Right or Rear
  • 3Rear Left Engine Mount: Rear Left
  • 4Front Engine Mount: Front

Install steps

Good to knowReplace all 4 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Automatic Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Engine Mount

    Rear Right or Rear. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Rear Left Engine Mount

    Rear Left. Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Front Engine Mount

    Front. Remove the old mount and bolt the new one in hand-tight.

  7. 7

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.