
ETK-768
How to install the 4 Piece Front & Rear Engine & Auto Trans Mount Kit
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
All 3 cars it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 2004–2007 | Ford | Freestar | V6 3.9L | |
| 2004–2007 | Ford | Freestar | V6 4.2L | |
| 2004–2007 | Mercury | Monterey | V6 4.2L |
What's in the box 4 pieces
1Engine Mount
Front Left or Front Right
2Engine Mount
Rear Right or Front Right
3Engine Torque Strut Mount
Front or Rear
4Automatic Transmission Mount
Where each piece goes
- 1Engine Mount: Front Left or Front Right
- 2Engine Mount: Rear Right or Front Right
- 3Engine Torque Strut Mount: Front or Rear
- 4Automatic Transmission Mount
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Engine Mount
Front Left or Front Right. Remove the old mount and bolt the new one in hand-tight.
- 4
Engine Mount
Rear Right or Front Right. Remove the old mount and bolt the new one in hand-tight.
- 5
Engine Torque Strut Mount
Front or Rear. Remove the old mount and bolt the new one in hand-tight.
- 6
Automatic Transmission Mount
Remove the old mount and bolt the new one in hand-tight.
- 7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.