4 Piece Front & Rear Engine Mount Kit

ETK-753

How to install the 4 Piece Front & Rear Engine Mount Kit

4 piecesFits 2007–2008 Chrysler Pacifica

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

The car it fits
YearsMakeModelEngineChoose
2007–2008ChryslerPacificaV6 3.8L

What's in the box 4 pieces

  • Front Engine Torque Strut Mount
    1

    Front Engine Torque Strut Mount

    Front

  • Engine Mount
    2

    2 × Engine Mount

    Front or Rear

  • Right Engine Mount
    3

    Right Engine Mount

    Right

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE1223
  • 1Front Engine Torque Strut Mount: Front
  • 2Engine Mount: Front or Rear
  • 3Right Engine Mount: Right

Install steps

Good to knowReplace all 4 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Front Engine Torque Strut Mount

    Front. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Engine Mount

    Front or Rear. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Right Engine Mount

    Right. Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.