3 Piece Front Engine Mount Kit

ETK-665

How to install the 3 Piece Front Engine Mount Kit

3 piecesFits 6 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 6 cars it fits
YearsMakeModelEngineChoose
2005–2009BuickLaCrosseV6 3.8L
2005–2008BuickLaCrosseV6 3.6L
2004–2008PontiacGrand PrixV6 3.8L
2005–2007BuickAllureV6 3.6L
2005–2007BuickAllureV6 3.8L
2000–2005ChevroletImpalaV6 3.4L

What's in the box 3 pieces

  • Engine Torque Strut Mount
    1

    2 × Engine Torque Strut Mount

    Front or Front Left

  • Engine Mount
    2

    Engine Mount

    Front Right or Right or Front Left or Front

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE112222
  • 1Engine Torque Strut Mount: Front or Front Left
  • 2Engine Mount: Front Right or Right or Front Left or Front

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Engine Torque Strut Mount

    Front or Front Left. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Engine Mount

    Front Right or Right or Front Left or Front. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.