
ETK-600
How to install the 4 Piece Front Engine & Auto Trans Mount Kit
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
All 3 cars it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 2004–2008 | Toyota | Solara | V6 3.3L | |
| 2004–2006 | Lexus | ES330 | V6 3.3L | |
| 2004–2006 | Toyota | Camry | V6 3.3L |
What's in the box 4 pieces
1Engine Mount
Front or Front Left
2Left Automatic Transmission Mount
Left
3Engine Torque Strut Mount
Front Right or Front
4Engine Mount
Right or Front Right
Where each piece goes
- 1Engine Mount: Front or Front Left
- 2Left Automatic Transmission Mount: Left
- 3Engine Torque Strut Mount: Front Right or Front
- 4Engine Mount: Right or Front Right
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Engine Mount
Front or Front Left. Remove the old mount and bolt the new one in hand-tight.
- 4
Left Automatic Transmission Mount
Left. Remove the old mount and bolt the new one in hand-tight.
- 5
Engine Torque Strut Mount
Front Right or Front. Remove the old mount and bolt the new one in hand-tight.
- 6
Engine Mount
Right or Front Right. Remove the old mount and bolt the new one in hand-tight.
- 7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.