2 Piece Front Engine Mount Kit

ETK-544

How to install the 2 Piece Front Engine Mount Kit

2 piecesFits 8 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 8 cars it fits
YearsMakeModelEngineChoose
1994–2002DodgeRam 2500V10 8.0L
1994–2002DodgeRam 2500V8 5.9L
1994–2002DodgeRam 3500V10 8.0L
1994–2002DodgeRam 3500V8 5.9L
1997–2001DodgeRam 1500V6 3.9L
1994–2001DodgeRam 1500V8 5.2L
1994–2001DodgeRam 1500V8 5.9L
1994–1996DodgeRam 2500V8 5.2L

What's in the box 2 pieces

  • Front Left Engine Mount
    1

    Front Left Engine Mount

    Front Left

  • Front Right Engine Mount
    2

    Front Right Engine Mount

    Front Right

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE12
  • 1Front Left Engine Mount: Front Left
  • 2Front Right Engine Mount: Front Right

Install steps

Good to knowReplace all 2 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Front Left Engine Mount

    Front Left. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Front Right Engine Mount

    Front Right. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.