ETK-393

How to install the 4 Piece Front Engine & Auto Trans Mount Kit

4 piecesFits 7 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 7 cars it fits

Years	Make	Model	Engine	Choose
1994–1999	Buick	LeSabre	V6 3.8L	Year
1994–1999	Oldsmobile	88	V6 3.8L	Year
1996–1999	Oldsmobile	LSS	V6 3.8L	Year
1994–1999	Pontiac	Bonneville	V6 3.8L	Year
1997–1998	Oldsmobile	Regency	V6 3.8L	Year
1994–1996	Buick	Park Avenue	V6 3.8L	Year
1994–1996	Oldsmobile	98	V6 3.8L	Year

What's in the box 4 pieces

Good to knowReplace all 4 together

1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
3
Front Engine Torque Strut Mount
Front. Remove the old mount and bolt the new one in hand-tight.
4
Rear Left Automatic Transmission Mount
Rear Left. Remove the old mount and bolt the new one in hand-tight.
5
Engine Mount
Front Right or Front. Remove the old mount and bolt the new one in hand-tight.
6
Front Left Automatic Transmission Mount
Front Left. Remove the old mount and bolt the new one in hand-tight.
7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.