ETK-2778
How to install the 4-Piece Front Rear Right Engine Mount & Torque Strut Set
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
All 4 cars it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 2014–2019 | INFINITI | QX60 | V6 3.5L | |
| 2015–2017 | Nissan | Murano | V6 3.5L | |
| 2013–2017 | Nissan | Pathfinder | V6 3.5L | |
| 2013 | INFINITI | JX35 | V6 3.5L |
What's in the box 4 pieces
1Rear Engine Torque Strut Mount
Rear
2Front Engine Torque Strut Mount
Front
3Rear Engine Mount
Rear
4Right Engine Mount
Right
Where each piece goes
- 1Rear Engine Torque Strut Mount: Rear
- 2Front Engine Torque Strut Mount: Front
- 3Rear Engine Mount: Rear
- 4Right Engine Mount: Right
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Rear Engine Torque Strut Mount
Rear. Remove the old mount and bolt the new one in hand-tight.
- 4
Front Engine Torque Strut Mount
Front. Remove the old mount and bolt the new one in hand-tight.
- 5
Rear Engine Mount
Rear. Remove the old mount and bolt the new one in hand-tight.
- 6
Right Engine Mount
Right. Remove the old mount and bolt the new one in hand-tight.
- 7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.