2-Piece Front Rear Auto Trans Mount Set

ETK-2653

How to install the 2-Piece Front Rear Auto Trans Mount Set

2 piecesFits 2005–2006 Honda Odyssey

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

The car it fits
YearsMakeModelEngineChoose
2005–2006HondaOdysseyV6 3.5L

What's in the box 2 pieces

  • Front Automatic Transmission Mount
    1

    Front Automatic Transmission Mount

    Front

  • Rear Automatic Transmission Mount
    2

    Rear Automatic Transmission Mount

    Rear

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE12
  • 1Front Automatic Transmission Mount: Front
  • 2Rear Automatic Transmission Mount: Rear

Install steps

Good to knowReplace all 2 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Front Automatic Transmission Mount

    Front. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Rear Automatic Transmission Mount

    Rear. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.