2-Piece Front Left Engine & Auto Trans Mount Set

ETK-2604

How to install the 2-Piece Front Left Engine & Auto Trans Mount Set

2 piecesFits 19 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 19 cars it fits
YearsMakeModelEngineChoose
2005–2009Mercedes-BenzSLK55 AMGV8 5.5L
2007–2008Mercedes-BenzE320V6 3.0L
2006–2007Mercedes-BenzC230V6 2.5L
2006–2007Mercedes-BenzC280V6 3.0L
2006–2007Mercedes-BenzC350V6 3.5L
2006Mercedes-BenzCL500V8 5.0L
2003–2006Mercedes-BenzCL55 AMGV8 5.5L
2005–2006Mercedes-BenzE320L6 3.2L

What's in the box 2 pieces

  • Engine Mount
    1

    Engine Mount

    Front Left or Front Right or Front or Right

  • Automatic Transmission Mount
    2

    Automatic Transmission Mount

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE1111
  • 1Engine Mount: Front Left or Front Right or Front or Right
  • 2Automatic Transmission Mount

Install steps

Good to knowReplace all 2 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Engine Mount

    Front Left or Front Right or Front or Right. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Automatic Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.