2-Piece Front Lower Engine Mount & Torque Strut Set

ETK-2568

How to install the 2-Piece Front Lower Engine Mount & Torque Strut Set

2 piecesFits 2013–2015 Honda Civic

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

The car it fits
YearsMakeModelEngineChoose
2013–2015HondaCivicL4 1.8L

What's in the box 2 pieces

  • Front Engine Mount
    1

    Front Engine Mount

    Front

  • Lower Engine Torque Strut Mount
    2

    Lower Engine Torque Strut Mount

    Rear Lower or Lower

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE122
  • 1Front Engine Mount: Front
  • 2Lower Engine Torque Strut Mount: Rear Lower or Lower

Install steps

Good to knowReplace all 2 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Front Engine Mount

    Front. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Lower Engine Torque Strut Mount

    Rear Lower or Lower. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.