3-Piece Front Rear Right Engine & Auto Trans Mount Set

ETK-2317

How to install the 3-Piece Front Rear Right Engine & Auto Trans Mount Set

3 piecesFits 4 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 4 cars it fits
YearsMakeModelEngineChoose
2000–2002VolkswagenCabrioL4 2.0L
1995–2000VolkswagenDerbyL4 1.8L
1993–1998VolkswagenGolfL4 2.0L
1993–1998VolkswagenJettaL4 2.0L

What's in the box 3 pieces

  • Front Engine Mount
    1

    Front Engine Mount

    Front

  • Engine Mount
    2

    Engine Mount

    Rear Right or Front Right

  • Automatic Transmission Mount
    3

    Automatic Transmission Mount

    Rear Left or Left

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE12233
  • 1Front Engine Mount: Front
  • 2Engine Mount: Rear Right or Front Right
  • 3Automatic Transmission Mount: Rear Left or Left

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Front Engine Mount

    Front. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Engine Mount

    Rear Right or Front Right. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Automatic Transmission Mount

    Rear Left or Left. Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.