ETK-214
How to install the 6 Piece Front Engine & Manual Trans Mount Kit
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
The car it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 1993–1995 | Acura | Legend | V6 3.2L |
What's in the box 6 pieces
12 × Engine Mount
Right or Left or Center
22 × Engine Mount
Front Right or Front Left or Front Lower
3Manual Transmission Mount
4Front Lower Engine Mount
Front Lower
Where each piece goes
- 1Engine Mount: Right or Left or Center
- 2Engine Mount: Front Right or Front Left or Front Lower
- 3Manual Transmission Mount
- 4Front Lower Engine Mount: Front Lower
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Engine Mount
Right or Left or Center. Remove the old mount and bolt the new one in hand-tight.
- 4
Engine Mount
Front Right or Front Left or Front Lower. Remove the old mount and bolt the new one in hand-tight.
- 5
Manual Transmission Mount
Remove the old mount and bolt the new one in hand-tight.
- 6
Front Lower Engine Mount
Front Lower. Remove the old mount and bolt the new one in hand-tight.
- 7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.