3-Piece Front Engine & Auto Trans Mount Set

ETK-2095

How to install the 3-Piece Front Engine & Auto Trans Mount Set

5 piecesFits 85 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 85 cars it fits
YearsMakeModelEngineChoose
1983–1989ChryslerFifth AvenueV8 5.2L
1977–1989DodgeDiplomatV8 5.2L
1975–1989PlymouthGran FuryV8 5.2L
1978–1988PlymouthCaravelleV8 5.2L
1975–1983ChryslerCordobaV8 5.2L
1981–1983ChryslerImperialV8 5.2L
1980–1983DodgeMiradaV8 5.2L
1979–1982ChryslerNew YorkerV8 5.2L

What's in the box 5 pieces

  • Engine Mount
    1

    2 × Engine Mount

    Front Left or Front Right

  • Engine Mount
    2

    2 × Engine Mount

    Front Left or Front Right or Front

  • Automatic Transmission Mount
    3

    Automatic Transmission Mount

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE11222
  • 1Engine Mount: Front Left or Front Right
  • 2Engine Mount: Front Left or Front Right or Front
  • 3Automatic Transmission Mount

Install steps

Good to knowReplace all 5 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Engine Mount

    Front Left or Front Right. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Engine Mount

    Front Left or Front Right or Front. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Automatic Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.