ETK-2005
How to install the 4-Piece Front Right Rear Engine Mount & Torque Strut Set
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
The car it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 2011–2015 | Audi | TTS Quattro | L4 2.0L |
What's in the box 4 pieces
1Engine Mount
Rear Lower or Front Lower or Front Left Lower
2Engine Mount
Rear Upper or Front Upper
3Engine Mount
Front or Front Right or Right
4Engine Mount
Rear or Front Lower
Where each piece goes
- 1Engine Mount: Rear Lower or Front Lower or Front Left Lower
- 2Engine Mount: Rear Upper or Front Upper
- 3Engine Mount: Front or Front Right or Right
- 4Engine Mount: Rear or Front Lower
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Engine Mount
Rear Lower or Front Lower or Front Left Lower. Remove the old mount and bolt the new one in hand-tight.
- 4
Engine Mount
Rear Upper or Front Upper. Remove the old mount and bolt the new one in hand-tight.
- 5
Engine Mount
Front or Front Right or Right. Remove the old mount and bolt the new one in hand-tight.
- 6
Engine Mount
Rear or Front Lower. Remove the old mount and bolt the new one in hand-tight.
- 7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.