3-Piece Front Engine & Manual Trans Mount Set

ETK-1950

How to install the 3-Piece Front Engine & Manual Trans Mount Set

3 piecesFits 6 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 6 cars it fits
YearsMakeModelEngineChoose
1991–1999ChevroletP30V8 5.7L
1994–1999ChevroletP30V8 6.5L
1991–1999GMCP3500V8 5.7L
1994–1999GMCP3500V8 6.5L
1991–1993ChevroletP30V8 6.2L
1991–1993GMCP3500V8 6.2L

What's in the box 3 pieces

  • Engine Mount
    1

    2 × Engine Mount

    Front or Front Left

  • Manual Transmission Mount
    2

    Manual Transmission Mount

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE11
  • 1Engine Mount: Front or Front Left
  • 2Manual Transmission Mount

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Engine Mount

    Front or Front Left. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Manual Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.