3-Piece Front Right Lower Engine & Auto Trans Mount Set

ETK-1880

How to install the 3-Piece Front Right Lower Engine & Auto Trans Mount Set

3 piecesFits 7 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 7 cars it fits
YearsMakeModelEngineChoose
2016–2021BMWX1L4 2.0L
2018–2021BMWX2L4 2.0L
2016–2020MiniCooperL3 1.5L
2017–2020MiniCooperL4 2.0L
2017–2020MiniCooper CountrymanL4 2.0L
2017–2019MiniCooper ClubmanL3 1.5L
2017–2019MiniCooper ClubmanL4 2.0L

What's in the box 3 pieces

  • Engine Mount
    1

    Engine Mount

    Front Right or Right

  • Automatic Transmission Mount
    2

    Automatic Transmission Mount

  • 3

    Engine Torque Strut Mount

    Lower or Front Lower or Rear Lower

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE11333
  • 1Engine Mount: Front Right or Right
  • 2Automatic Transmission Mount
  • 3Engine Torque Strut Mount: Lower or Front Lower or Rear Lower

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Engine Mount

    Front Right or Right. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Automatic Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Engine Torque Strut Mount

    Lower or Front Lower or Rear Lower. Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.