3-Piece Front Left & Right Engine & Auto Trans Mount Set

ETK-1875

How to install the 3-Piece Front Left & Right Engine & Auto Trans Mount Set

3 piecesFits 6 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 6 cars it fits
YearsMakeModelEngineChoose
2017–2020BMW430i xDriveL4 2.0L
2017–2020BMW430i xDrive Gran CoupeL4 2.0L
2017–2019BMW330i GT xDriveL4 2.0L
2017–2019BMW330i xDriveL4 2.0L
2013–2017BMW320i xDriveL4 2.0L
2014–2017BMW328d xDriveL4 2.0L

What's in the box 3 pieces

  • Engine Mount
    1

    Engine Mount

    Front Left or Left

  • Engine Mount
    2

    Engine Mount

    Front Right or Right

  • Automatic Transmission Mount
    3

    Automatic Transmission Mount

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE1122
  • 1Engine Mount: Front Left or Left
  • 2Engine Mount: Front Right or Right
  • 3Automatic Transmission Mount

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Engine Mount

    Front Left or Left. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Engine Mount

    Front Right or Right. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Automatic Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.