3-Piece Front Left & Right Engine & Auto Trans Mount Set

ETK-1874

How to install the 3-Piece Front Left & Right Engine & Auto Trans Mount Set

3 piecesFits 9 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 9 cars it fits
YearsMakeModelEngineChoose
2017–2020BMW230i xDriveL4 2.0L
2015–2018BMWX4L4 2.0L
2013–2017BMWX3L4 2.0L
2015–2016BMW228i xDriveL4 2.0L
2014–2016BMW328i GT xDriveL4 2.0L
2013–2016BMW328i xDriveL4 2.0L
2014–2016BMW428i xDriveL4 2.0L
2015–2016BMW428i xDrive Gran CoupeL4 2.0L

What's in the box 3 pieces

  • Engine Mount
    1

    Engine Mount

    Front Left or Left

  • Engine Mount
    2

    Engine Mount

    Front Right or Right

  • Automatic Transmission Mount
    3

    Automatic Transmission Mount

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE1122
  • 1Engine Mount: Front Left or Left
  • 2Engine Mount: Front Right or Right
  • 3Automatic Transmission Mount

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Engine Mount

    Front Left or Left. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Engine Mount

    Front Right or Right. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Automatic Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.