3-Piece Front Right Rear Engine & Auto Trans Mount Set

ETK-1855

How to install the 3-Piece Front Right Rear Engine & Auto Trans Mount Set

3 piecesFits 2016–2018 Hyundai Tucson

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

The car it fits
YearsMakeModelEngineChoose
2016–2018HyundaiTucsonL4 2.0L

What's in the box 3 pieces

  • Engine Mount
    1

    Engine Mount

    Front Right or Right

  • 2

    Automatic Transmission Mount

  • Rear Engine Mount
    3

    Rear Engine Mount

    Rear

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE113
  • 1Engine Mount: Front Right or Right
  • 2Automatic Transmission Mount
  • 3Rear Engine Mount: Rear

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Engine Mount

    Front Right or Right. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Automatic Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Rear Engine Mount

    Rear. Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.