
ETK-1760
How to install the 4-Piece Front Rear Left Right Lower Engine & Auto Trans Mount Set
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
All 3 cars it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 2013–2015 | Honda | Crosstour | L4 2.4L | |
| 2009–2012 | Acura | TSX | L4 2.4L | |
| 2009–2012 | Honda | Accord | L4 2.4L |
What's in the box 4 pieces
1Front Engine Mount
Front
2Rear Left Engine Mount
Rear Left
3Engine Mount
Right or Front Right
4Lower Automatic Transmission Mount
Lower
Where each piece goes
- 1Front Engine Mount: Front
- 2Rear Left Engine Mount: Rear Left
- 3Engine Mount: Right or Front Right
- 4Lower Automatic Transmission Mount: Lower
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Front Engine Mount
Front. Remove the old mount and bolt the new one in hand-tight.
- 4
Rear Left Engine Mount
Rear Left. Remove the old mount and bolt the new one in hand-tight.
- 5
Engine Mount
Right or Front Right. Remove the old mount and bolt the new one in hand-tight.
- 6
Lower Automatic Transmission Mount
Lower. Remove the old mount and bolt the new one in hand-tight.
- 7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.