ETK-1728
How to install the 4-Piece Left & Right Engine & Manual Trans Mount Set
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
All 2 cars it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 2013–2015 | Nissan | Sentra | L4 1.8L | |
| 2011–2012 | Nissan | Juke | L4 1.6L |
What's in the box 4 pieces
1Right Engine Torque Strut Mount
Right
2Left Engine Torque Strut Mount
Left
3Right Engine Mount
Right
4Rear Automatic Transmission Mount
Rear
Where each piece goes
- 1Right Engine Torque Strut Mount: Right
- 2Left Engine Torque Strut Mount: Left
- 3Right Engine Mount: Right
- 4Rear Automatic Transmission Mount: Rear
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Right Engine Torque Strut Mount
Right. Remove the old mount and bolt the new one in hand-tight.
- 4
Left Engine Torque Strut Mount
Left. Remove the old mount and bolt the new one in hand-tight.
- 5
Right Engine Mount
Right. Remove the old mount and bolt the new one in hand-tight.
- 6
Rear Automatic Transmission Mount
Rear. Remove the old mount and bolt the new one in hand-tight.
- 7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.