ETK-1679
How to install the 5-Piece Front Lower Engine & Auto Trans Mount Set
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
The car it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 2001–2008 | Volvo | S60 | L5 2.4L |
What's in the box 5 pieces
12 × Engine Mount
Front or Rear Lower or Rear or Front Lower
2Lower Engine Torque Strut Mount
Lower
3Automatic Transmission Mount
4Front Upper Engine Mount
Front Upper or Rear Upper
Where each piece goes
- 1Engine Mount: Front or Rear Lower or Rear or Front Lower
- 2Lower Engine Torque Strut Mount: Lower
- 3Automatic Transmission Mount
- 4Front Upper Engine Mount: Front Upper or Rear Upper
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Engine Mount
Front or Rear Lower or Rear or Front Lower. Remove the old mount and bolt the new one in hand-tight.
- 4
Lower Engine Torque Strut Mount
Lower. Remove the old mount and bolt the new one in hand-tight.
- 5
Automatic Transmission Mount
Remove the old mount and bolt the new one in hand-tight.
- 6
Front Upper Engine Mount
Front Upper or Rear Upper. Remove the old mount and bolt the new one in hand-tight.
- 7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.