3-Piece Left & Right Engine & Auto Trans Mount Set

ETK-1599

How to install the 3-Piece Left & Right Engine & Auto Trans Mount Set

3 piecesFits 8 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 8 cars it fits
YearsMakeModelEngineChoose
1999–2019FordE-350 Super DutyV10 6.8L
2003–2019FordE-450 Super DutyV10 6.8L
2003FordE-350 Club WagonV10 6.8L
2003FordE-550 Super DutyV10 6.8L
1997–2002FordE-350 Econoline Club WagonV10 6.8L
2000–2002FordE-450 Econoline Super DutyV10 6.8L
1997–1999FordEconoline Super DutyV10 6.8L
1997–1998FordE-350 EconolineV10 6.8L

What's in the box 3 pieces

  • 1

    Left Engine Mount

    Left

  • Right Engine Mount
    2

    Right Engine Mount

    Right

  • Manual Transmission Mount
    3

    Manual Transmission Mount

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE12
  • 1Left Engine Mount: Left
  • 2Right Engine Mount: Right
  • 3Manual Transmission Mount

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Left Engine Mount

    Left. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Right Engine Mount

    Right. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Manual Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.