3-Piece Front Left & Right Engine & Auto Trans Mount Set

ETK-1590

How to install the 3-Piece Front Left & Right Engine & Auto Trans Mount Set

3 piecesFits 1997–1999 Ford F-250

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

The car it fits
YearsMakeModelEngineChoose
1997–1999FordF-250V8 4.6L

What's in the box 3 pieces

  • Front Left Engine Mount
    1

    Front Left Engine Mount

    Front Left

  • Front Right Engine Mount
    2

    Front Right Engine Mount

    Front Right

  • Manual Transmission Mount
    3

    Manual Transmission Mount

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE12
  • 1Front Left Engine Mount: Front Left
  • 2Front Right Engine Mount: Front Right
  • 3Manual Transmission Mount

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Front Left Engine Mount

    Front Left. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Front Right Engine Mount

    Front Right. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Manual Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.