3-Piece Front Left & Right Engine & Auto Trans Mount Set

ETK-1574

How to install the 3-Piece Front Left & Right Engine & Auto Trans Mount Set

3 piecesFits 7 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 7 cars it fits
YearsMakeModelEngineChoose
1990–1997FordRangerV6 4.0L
1994–1997MazdaB4000V6 4.0L
1994–1996MazdaB3000V6 3.0L
1991–1994FordExplorerV6 4.0L
1992–1994MazdaNavajoV6 4.0L
1986–1992FordRangerV6 2.9L
1986–1990FordBronco IIV6 2.9L

What's in the box 3 pieces

  • Engine Mount
    1

    Engine Mount

    Front Left or Front

  • Front Right Engine Mount
    2

    Front Right Engine Mount

    Front Right

  • Manual Transmission Mount
    3

    Manual Transmission Mount

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE112
  • 1Engine Mount: Front Left or Front
  • 2Front Right Engine Mount: Front Right
  • 3Manual Transmission Mount

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Engine Mount

    Front Left or Front. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Front Right Engine Mount

    Front Right. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Manual Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.