ETK-155
How to install the 5 Piece Front Engine & Auto Trans & Manual Trans Mount Kit
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
The car it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 2003–2007 | Honda | Accord | V6 3.0L |
What's in the box 5 pieces
1Rear Automatic Transmission Mount
Rear
2Front Automatic Transmission Mount
Front
3Manual Transmission Mount
Upper or Front Upper
4Front Engine Mount
Front
5Engine Mount
Right or Front Right
Where each piece goes
- 1Rear Automatic Transmission Mount: Rear
- 2Front Automatic Transmission Mount: Front
- 3Manual Transmission Mount: Upper or Front Upper
- 4Front Engine Mount: Front
- 5Engine Mount: Right or Front Right
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Rear Automatic Transmission Mount
Rear. Remove the old mount and bolt the new one in hand-tight.
- 4
Front Automatic Transmission Mount
Front. Remove the old mount and bolt the new one in hand-tight.
- 5
Manual Transmission Mount
Upper or Front Upper. Remove the old mount and bolt the new one in hand-tight.
- 6
Front Engine Mount
Front. Remove the old mount and bolt the new one in hand-tight.
- 7
Engine Mount
Right or Front Right. Remove the old mount and bolt the new one in hand-tight.
- 8
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.