ETK-1531

How to install the 4-Piece Front Rear Right Engine & Auto Trans Mount Set

4 piecesFits 2 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 2 cars it fits

Years	Make	Model	Engine	Choose
2013–2016	Cadillac	SRX	V6 3.6L	Year
2010–2011	Cadillac	SRX	V6 3.0L	Year

What's in the box 4 pieces

Good to knowReplace all 4 together

1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
3
Right Engine Mount
Right. Remove the old mount and bolt the new one in hand-tight.
4
Front Automatic Transmission Mount
Front. Remove the old mount and bolt the new one in hand-tight.
5
Center Automatic Transmission Mount
Center. Remove the old mount and bolt the new one in hand-tight.
6
Rear Automatic Transmission Mount
Rear. Remove the old mount and bolt the new one in hand-tight.
7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.