ETK-1522
How to install the 3-Piece Rear Right Engine & Auto Trans Mount Set
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
The car it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 2011–2014 | Mazda | 2 | L4 1.5L |
What's in the box 3 pieces
1Right Engine Mount
Right or Front Right
2Automatic Transmission Mount
3Rear Engine Torque Strut Mount
Rear
Where each piece goes
- 1Right Engine Mount: Right or Front Right
- 2Automatic Transmission Mount
- 3Rear Engine Torque Strut Mount: Rear
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Right Engine Mount
Right or Front Right. Remove the old mount and bolt the new one in hand-tight.
- 4
Automatic Transmission Mount
Remove the old mount and bolt the new one in hand-tight.
- 5
Rear Engine Torque Strut Mount
Rear. Remove the old mount and bolt the new one in hand-tight.
- 6
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.