3 Piece Front & Rear Engine & Auto Trans Mount Kit

ETK-1301

How to install the 3 Piece Front & Rear Engine & Auto Trans Mount Kit

3 piecesFits 2 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 2 cars it fits
YearsMakeModelEngineChoose
2015–2019LincolnMKCL4 2.0L
2015–2019LincolnMKCL4 2.3L

What's in the box 3 pieces

  • Upper Automatic Transmission Mount
    1

    Upper Automatic Transmission Mount

    Upper

  • Engine Mount Bushing
    2

    Engine Mount Bushing

    Right or Front Right

  • Rear Engine Torque Strut Mount
    3

    Rear Engine Torque Strut Mount

    Rear

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE1223
  • 1Upper Automatic Transmission Mount: Upper
  • 2Engine Mount Bushing: Right or Front Right
  • 3Rear Engine Torque Strut Mount: Rear

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Upper Automatic Transmission Mount

    Upper. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Engine Mount Bushing

    Right or Front Right. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Rear Engine Torque Strut Mount

    Rear. Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.