3 Piece Front Engine & Manual Trans Mount Kit

ETK-1281

How to install the 3 Piece Front Engine & Manual Trans Mount Kit

3 piecesFits 12 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 12 cars it fits
YearsMakeModelEngineChoose
2011–2013Ram4500L6 6.7L
2011–2013Ram5500L6 6.7L
2011–2012Ram2500L6 6.7L
2011–2012Ram3500L6 6.7L
2011–2012Ram4000L6 6.7L
2007–2010DodgeRam 2500L6 6.7L
2010DodgeRam 4000L6 6.7L
2008–2010DodgeRam 4500L6 6.7L

What's in the box 3 pieces

  • Manual Transmission Mount
    1

    Manual Transmission Mount

  • Engine Mount
    2

    Engine Mount

    Front Left or Left

  • Engine Mount
    3

    Engine Mount

    Front Right or Right

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE2233
  • 1Manual Transmission Mount
  • 2Engine Mount: Front Left or Left
  • 3Engine Mount: Front Right or Right

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Manual Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Engine Mount

    Front Left or Left. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Engine Mount

    Front Right or Right. Remove the old mount and bolt the new one in hand-tight.

  6. 6

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.