ETK-1215

How to install the 4 Piece Engine & Auto Trans Mount Kit

4 piecesFits 3 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 3 cars it fits

Years	Make	Model	Engine	Choose
2012–2015	Chevrolet	Captiva Sport	L4 2.4L	Year
2010–2015	Chevrolet	Equinox	L4 2.4L	Year
2010–2015	GMC	Terrain	L4 2.4L	Year

What's in the box 4 pieces

Good to knowReplace all 4 together

1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
3
Front Automatic Transmission Mount
Front. Remove the old mount and bolt the new one in hand-tight.
4
Rear Automatic Transmission Mount
Rear. Remove the old mount and bolt the new one in hand-tight.
5
Right Engine Mount
Right. Remove the old mount and bolt the new one in hand-tight.
6
Center Automatic Transmission Mount
Center. Remove the old mount and bolt the new one in hand-tight.
7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.