2 Piece Engine & Auto Trans Mount Kit

ETK-1203

How to install the 2 Piece Engine & Auto Trans Mount Kit

2 piecesFits 4 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 4 cars it fits
YearsMakeModelEngineChoose
2014–2017BuickRegalL4 2.0L
2011–2016BuickLaCrosseV6 3.6L
2012–2016CadillacSRXV6 3.6L
2010–2011CadillacSRXV6 3.0L

What's in the box 2 pieces

  • Front Automatic Transmission Mount
    1

    Front Automatic Transmission Mount

    Front

  • Rear Automatic Transmission Mount
    2

    Rear Automatic Transmission Mount

    Rear

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE12
  • 1Front Automatic Transmission Mount: Front
  • 2Rear Automatic Transmission Mount: Rear

Install steps

Good to knowReplace all 2 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Front Automatic Transmission Mount

    Front. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Rear Automatic Transmission Mount

    Rear. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.