ETK-1090
How to install the 4 Piece Front Engine & Auto Trans Mount Kit
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
All 2 cars it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 2008 | Chevrolet | Malibu | L4 2.4L | |
| 2008 | Pontiac | G6 | L4 2.4L |
What's in the box 4 pieces
1Automatic Transmission Mount
Rear or Rear Left or Front Left
2Engine Mount
Front Right or Front or Right
3Front Automatic Transmission Mount
Front
4Center Automatic Transmission Mount
Center
Where each piece goes
- 1Automatic Transmission Mount: Rear or Rear Left or Front Left
- 2Engine Mount: Front Right or Front or Right
- 3Front Automatic Transmission Mount: Front
- 4Center Automatic Transmission Mount: Center
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Automatic Transmission Mount
Rear or Rear Left or Front Left. Remove the old mount and bolt the new one in hand-tight.
- 4
Engine Mount
Front Right or Front or Right. Remove the old mount and bolt the new one in hand-tight.
- 5
Front Automatic Transmission Mount
Front. Remove the old mount and bolt the new one in hand-tight.
- 6
Center Automatic Transmission Mount
Center. Remove the old mount and bolt the new one in hand-tight.
- 7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.