ETK-1021
How to install the 6 Piece Front Engine & Auto Trans Mount Kit
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
The car it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 1997–2004 | Buick | Regal | V6 3.8L |
What's in the box 6 pieces
1Engine Mount
Front Right or Front
2Automatic Transmission Mount
32 × Engine Torque Strut Mount
Front or Front Left
42 × Front Engine Torque Strut Mount
Front
Where each piece goes
- 1Engine Mount: Front Right or Front
- 2Automatic Transmission Mount
- 3Engine Torque Strut Mount: Front or Front Left
- 4Front Engine Torque Strut Mount: Front
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Engine Mount
Front Right or Front. Remove the old mount and bolt the new one in hand-tight.
- 4
Automatic Transmission Mount
Remove the old mount and bolt the new one in hand-tight.
- 5
Engine Torque Strut Mount
Front or Front Left. Remove the old mount and bolt the new one in hand-tight.
- 6
Front Engine Torque Strut Mount
Front. Remove the old mount and bolt the new one in hand-tight.
- 7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.