ETK-1013
How to install the 4 Piece Front Engine & Auto Trans Mount Kit
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
All 3 cars it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 2004–2005 | Chevrolet | Classic | L4 2.2L | |
| 2002–2005 | Pontiac | Grand Am | L4 2.2L | |
| 2002–2004 | Oldsmobile | Alero | L4 2.2L |
What's in the box 4 pieces
1Automatic Transmission Mount
Center or Front
2Front Left Automatic Transmission Mount
Front Left
3Engine Mount
Right or Front
4Automatic Transmission Mount
Rear Left or Rear
Where each piece goes
- 1Automatic Transmission Mount: Center or Front
- 2Front Left Automatic Transmission Mount: Front Left
- 3Engine Mount: Right or Front
- 4Automatic Transmission Mount: Rear Left or Rear
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Automatic Transmission Mount
Center or Front. Remove the old mount and bolt the new one in hand-tight.
- 4
Front Left Automatic Transmission Mount
Front Left. Remove the old mount and bolt the new one in hand-tight.
- 5
Engine Mount
Right or Front. Remove the old mount and bolt the new one in hand-tight.
- 6
Automatic Transmission Mount
Rear Left or Rear. Remove the old mount and bolt the new one in hand-tight.
- 7
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.