3 Piece Front Engine & Auto Trans Mount Kit

ETK-006

How to install the 3 Piece Front Engine & Auto Trans Mount Kit

3 piecesFits 19 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 19 cars it fits
YearsMakeModelEngineChoose
2007–2014CadillacEscaladeV8 6.2L
2007–2014CadillacEscalade ESVV8 6.2L
2007–2014ChevroletSuburban 1500V8 5.3L
2007–2014GMCYukonV8 6.2L
2007–2014GMCYukon XL 1500V8 5.3L
2007–2014GMCYukon XL 1500V8 6.2L
2007–2013CadillacEscalade EXTV8 6.2L
2007–2013ChevroletAvalancheV8 5.3L

What's in the box 3 pieces

  • Automatic Transmission Mount
    1

    Automatic Transmission Mount

  • Front Engine Mount
    2

    2 × Front Engine Mount

    Front

Where each piece goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE2
  • 1Automatic Transmission Mount
  • 2Front Engine Mount: Front

Install steps

Good to knowReplace all 3 together
  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Automatic Transmission Mount

    Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Front Engine Mount

    Front. Remove the old mount and bolt the new one in hand-tight.

  5. 5

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.