
EM-8095
How to install the Rear Manual Transmission Mount
RearFits 7 cars
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
All 7 cars it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 1987–1993 | Mazda | B2200 | L4 2.2L | |
| 1987–1993 | Mazda | B2600 | L4 2.6L | |
| 1979–1987 | Mazda | B2000 | L4 2.0L | |
| 1979–1985 | Mazda | RX-7 | R2 1.1L | |
| 1984–1985 | Mazda | RX-7 | R2 1.3L | |
| 1979–1980 | Mazda | GLC | L4 1.4L | |
| 1972–1976 | Mazda | B1600 | L4 1.6L |
Where it goes
- 1Rear Manual Transmission Mount: Rear
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Rear Manual Transmission Mount
Rear. Remove the old mount and bolt the new one in hand-tight.
- 4
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.